Specifications

Note: Do not attempt to move an existing database by changing the location listed in the

Database Location field. See instructions about creating a new database location.

If you change the location listed in the Database Location field without first moving the database

manually, you will receive a message asking, "Do you wish to create a new database?" If you click OK,

Remote Link creates a new database at the location that you just assigned and ignores the previous

database. This means you will not have access to any previous account information and

configurations settings from the previously existing Remote Link database.

Note: If you are using Remote Link on a computer connected to a network, run the Remote

Link program from your local hard drive, not from a network drive. Remote Link accesses the

database more quickly if the database is located on the local computer than if it is located on

a network drive. Only one computer at a time may use a Remote Link database.

System > Log ON / OFF

Before using Remote Link, you must log in to the program with a user name and password. When you

open Remote Link, the Log On window automatically displays. You may log off and then log in as

another user any time the program is open.

The default log in is new for both your user name and password. Be sure the Caps Lock is not on.

Note: Keep track of your passwords and remember to always keep them in a safe location.

To configure Remote Link to directly connect to a panel, follow the steps below:

Select the desired panel in File > Panel Information.

In the Connection Information group box, select Direct from the drop-down menu in the Type field.

Select the COM Port to which the panel is connected.

Select the Baud Rate of the COM Port.

Note: You only need to complete these steps one time. On further connections simply select

the panel and then Connect as explained below.

After you have entered all the Connection Information, open the panel by clicking OK. Then go to

Panel > Connect and click the Connect button. You are now connected to the panel.

To configure Remote Link to connect to a panel through an SCS-1, SCS-1R, SCS-VR or SCS-105

Receiver using a dial-up connection, follow the steps below:

Select the desired panel in File > Panel Information.

In the Connection Information group box, select SCS-1 / SCS-105 from the drop-down menu in the

Type field.

Enter the Remote Key.

Enter the phone number of the panel.

Select Yes from the drop-down menu in the Dial field.