Specifications

© 2015 Digital Monitoring Products
Send Message to a Printer
If you wish to send the message to a printer connected to the panel, select the Printer option and
click the Send button.
Note: If you send a message to a printer, there must be a printer connected to the panel that
is turned on and ready to print. If the printer is not ready to print, your message will be lost.
Remote Link will confirm that your message was sent to the panel successfully, but Remote
Link cannot confirm that the message actually printed.
When the Send Message command is successful, you will see "Message Sent Successfully" in a pop-up
window.
If no options are checked in Program > Printer Reports, you will receive a "Printer not enabled"
message.
Send a Service man Message
On model 1512, 1812, and 1912 panels, you may also use the Send Message feature to send a Service
man message to the panel. Enter the message in the Message to Send field, select Service man, and
click Send. When the technician on-site accesses programming at the panel, the Service man
message will display on keypad address number one.
When the Send Message command is successful, you will see "Message Sent Successfully" in a pop-up
window.
Panel > System Status > Area Status
Remote Link will display the arm/disarm status of all areas assigned to the panel in the Area Status
window. You may arm or disarm each area individually. To open the Area Status window, select Panel
> System Status, and click on the Areas button.
The Area Status window displays the following information:
Area: The number of the area.
Name: The name assigned to the area.
Current Status: The current arm/disarm status of the area.
Desired Action: Select Arm or Disarm from the drop-down menu to change the status of the
area.
How to Arm and Disarm
To arm or disarm an active area, select that area from the Area Status list and click on the
arrow to open the drop-down menu, as shown in the picture above. Select Arm or Disarm form
the drop-down list. Click on the Arm/Disarm button near the bottom of the window to send that
information to the panel.
When you arm or disarm an area, a pop-up window appears to notify you of successful arming or
disarming.
Bad Zone Action
Area Status Messages
Panel > System Status > Zo ne Status
The Zone Status window allows you to view the status of all zones assigned to a panel. Select Panel >