Troubleshooting guide

-PANEL WON’T ARM- (CONT’D)

Arming Procedure Chart

Mode Closing Code = YES

HOME/AWAY Enter code, choose HOME or AWAY

ALL/PERIM Enter code, choose ALL or PERIM

AREA

SYSTEM

Press COMMAND until [ ARM DISARM ] displays. Select

ARM. Panel will prompt [ ENTER CODE ].

YES will arm all areas that the User Code has authority to

arm. NO will scroll through the areas assigned to the User

Code, followed by YES NO.

Mode Closing Code = NO

HOME/AWAY Press COMMAND until [ HOME AWAY ] appears. Make

selection.

ALL/PERIM Press COMMAND until [ PERIM ALL ] appears. Make

selection.

AREA

SYSTEM

Press COMMAND until [ ARM DISARM ] appears, select ARM.

[ ALL? YES NO ] will appear.

YES will arm all areas. NO scrolls each area programmed for

the partition, followed by YES NO.

TECH NOTE: The Closing Code option is programmed in SYSTEM OPTIONS on XRSuper6,

XR6/10, XR20 and XR40 panels.

XR200, XR2400F, XR200/485 and XR500 series panels have this option in AREA

INFORMATION.

4) Does keypad respond to any

key presses?

* If not, check keypad bus devices for duplicate addresses

5) Is keypad address ‘turned on’ in Menu Display for Arm/Disarm?

* If not, the keypad never displays the arming prompt. Check Menu Display programming.

-NOTES-

_____________