Troubleshooting guide

14
Setting Address on 770 Series Keypads
These keypads use binary dipswitches to set the address. The table below shows the
correct address settings with the switch positions indicated in black…
TECH NOTE: 733 modules and old style (1 EEPROM) 770 series keypads CANNOT be set
to Unsupervised addresses.
Setting Keypad Bus Address for Devices - XR200/485 & XR500
The XR200-485 allows up to 16 devices to be connected and addressed on the Keypad Bus.
Switch positions are indicated in black in the drawing below.
TECH NOTE: 733 Modules and old style (1 EEPROM) 770 series keypads CAN NOT be set
to Unsupervised addresses.
-NOTES-
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
_____________
770 series keypad
Dipswitch locatio
n