Troubleshooting guide

Addressing Devices

Setting Address on 690/790 series keypads

1. Press and hold the COMMAND and Back Arrow keys until [ SET BRIGHTNESS ] appears on

display

2. Enter 3577 (I-N-S-T) + COMMAND

3. Press key under KPD OPT (Keypad Options)

4. Keypad displays [ CURRENT KEYPAD ADDRESS: xx ] (xx = address 01-16)

5. Press any top row (Select) key

6. Enter desired address. (Do not enter leading zeroes.) Press COMMAND to scroll to next

option.

7. [ KEYPAD MODE: SUP UNSUP ] To choose Supervised or Unsupervised operation, press

select key under SUP or UNSUP. Press COMMAND

8. [ DEFAULT KEYPAD MSG ] Enter message to be displayed on top row of display. Press

COMMAND

9. [ ARM PANIC KEYS: PN EM FI ] Press select keys below each to enable. When enabled,

each will appear as *PN *EM *FI. (report as Zones: PN=19,EM=29, FI=39) Press

COMMAND

10. [ ACTIVATE ZONE 2 SHUNT: NO ] - Used w/ 693,791,793 keypads for Soft Shunt function.

Press COMMAND

11. [ ACTIVATE ZONE 3 EXIT: NO ] – Also used with above keypads for REX function. Press

COMMAND

12. [ 4 DIGIT ENTRY CARDS: NO ] – Select YES for Home/Away or other systems that require

4 digit codes. Press COMMAND

13. [ ALL? NO YES DELAY: 2 ] – This option is for use in an Area Mode system. When

arming, ALL? YES NO is displayed on the keypad. When NO or YES is not selected before

this delay (1 to 9 seconds) expires, the keypad automatically selects YES. Enter zero to

disable this feature. Press the COMMAND key.

14. [ KPD OPT KPD DIAG STOP ] – Press select key under STOP

See LT-0291 for more details.

690 / 790 series ke

-NOTES-

_____________