User`s guide

User Menu XT30/XT50 User’s Guide 29
Schedules
User Code Level: Master only.
Function: The Schedules function allows you to program the times
at which you normally turn your burglary protection on and off
each day of the week. This information can then be used by the
system to automatically arm or disarm the burglary protection.
Your system may be pre-programmed at installation to allow
automatic arming and disarming. When programmed, you can
enter a schedule for the arming and disarming times.
You can also use the Closing Check/Extend feature with Schedules
toensureyoursystemisarmedbyanauthorizeduserataspecic
time. This option sounds the keypad buzzer and displays CLOSING
TIME! when a schedule expires. Users still on the premises are
required to arm the system or extend the schedule. If the system
is not armed, or the schedule not extended, a report can be sent
to the central station and/or an email address or cell phone.
When a schedule expires and CLOSING TIME! displays, the keypad
next displays ENTER CODE: -. To silence the keypad buzzer and
extend the schedule for one hour, a user must either enter a valid
user code or present a card to the card reader.
Also, when a closing schedule expires, your system may turn on
the Late to Close Output. This output turns off anytime your
system is armed, or a schedule is extended or changed. See
System Setup for Output information.
Your system provides you with three different types of schedules:
Permanent schedules are used for automatic arming and
disarming and always occur at the same time until you change or
delete them.
Extend schedules allow an authorized user to extend the present
day's permanent scheduled closing time.
Output schedules are used for automatically turning your system
outputs ON and OFF and always occur at the same time until you
change or delete them. See System Setup for Output information.
Permanent Schedules
User Code Level: Master only.
1. Access the User Menu.
2. Press the COMMAND key until SCHEDULES? displays. Press any
Select key. The keypad displays PRM EXT OUT. Select PRM.
3. The keypad next displays the day of the week you want
the schedule to start as SUN MON TUE WED. Press the
COMMAND key to show the remaining days of the week and
then Select the start day.
4. The keypad displays OPENING TIME?. Press COMMAND. The
keypad now displays MON – : AM PM. Enter the time you
want the burglary protection to be turned off. Use a 12 hour
clock only (12:00 to 11:59). Select AM or PM.
5. The keypad then displays CLOSING TIME?. Press the
COMMAND key. The keypad then displays MON – : AM
PM. If you want the schedule to be for consecutive days,
Select MON to increment the days of the week. When the
correct day is shown, enter the time you want the burglary
protection to turn on.
6. To clear a schedule, press DELETE and then AM when the
opening time is requested. Press the Back Arrow key to exit
the User Menu.