Specifications

Digital Monitoring Products 690/690F/790/790F/791/793 Installation Sheet
8
690/690F/790/790F/791/793 Installation Sheet Digital Monitoring Products
9
791/793 Easy Entry Keypad Additional Programming
The 793 keypad allows users to present a proximity credential to an access control reader that in turn sends their
user code to the keypad. Users can also manually enter their user code into the keypad. The keypad reads the
user code, veries its authority with the panel, and then powers its on-board Form C relay releasing a door strike or
magnetic lock.
Programming Cards into the System
The programming feature operates on 793 keypads only. Access the User Menu in one of two ways. When MENU? NO
YES displays, present your proximity card to the reader or manually enter your user code into the keypad.
From the User Menu, select USER CODES?. Choose ADD. At the ENTER CODE: - display, present the user card to the
reader. The keypad works by reading the 4 or 5-digit user code from the data sent by the access control reader. For
more information, refer to Entry Cards in the programming section of this document and the following User’s Guide
section on adding, deleting, and changing user codes.
Keypad User’s Guide
There are three different operating modes: Door Strike, Arming and Disarming, and Entry Delay. All of the examples
below assume that CLOSING CODE is YES in panel programming.
Door Strike
Area and All/Perimeter Door Strike. From the Status List, present your card to the reader. Once the system validates
the card, the Door Strike relay activates. Home/Away systems only activate the Door Strike relay when arming and
disarming.
ABC SECURITY
ARM DISARM
While the keypad is in
the Status List, present
your access card
.
The relay activates for 5 seconds during which
time you can open the door. Once you open
the door, you have 40 seconds to exit and close
the door before the Zone 2 Soft-Shunt expires.
Figure 8: Present Access Card
Arming and Disarming
Area system Arming and Disarming. Press COMMAND, the keypad displays ARM DISARM. Press the Select key under
either option. The keypad displays ENTER CODE: -. Present your card to the reader. Once validated by the system,
all areas accessible by you arm or disarm automatically and the Door Strike relay activates.
ABC SECURITY
ARM DISARM
ABC SECURITY
ENTER CODE: –
ABC SECURITY
ALL? NO YES
POWER
POWER
POWER
Select NO to arm or disarm individual areas.
Select YES, or simply wait, to automatically arm or disarm all areas for which you are authorized.
Figure 9: Area Arming and Disarming