User`s guide

3 - HARDWARE DESCRIPTION
10
SCS-1 Install/User's Guide
2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282
MODEL SCS-203 CONVENIENCE PANEL
3.9 Description
The SCS-203 provides cabling for three RS-232 ports. The three ports are for the CRT display, host output, and
activity log printer.
To Port 6
To Port 8
To
Port 7
To
SCS-110
To
Activity Log
Printer
To
Host Computer
To
CRT
3.9A Installation
Install the three 10 position flat cable connectors to ports 6, 7 and 8 of the processor card. Install the metal plate
with the three 25 position RS-232 connectors on the receiver backplate using the two 6-32 x 1/4" screws
provided. Connect the CRT display, printers and/or host computer to the RS-232 connectors.
MODEL SCS-PTR PRINTER AND CABLE
3.10 Description
The SCS-PTR is an 80 column printer with a 10' RS-232 cable. The printer can be connected to the all events
output connector or the alarm only output connector. See Section 3.9. The SCS-1 Receiver is shipped with one
printer.
3.10AInstallation
The printer as shipped by DMP has all option switches preset. Install the RS-232 cable between the printer serial
interface port and the receiver convenience panel connector. Remove any dummy plugs from the printer output
connector. If a printer is not being installed, the dummy plug shorting pins 4 and 5 should remain on the
connector.
THE END OF THE CABLE MARKED PRINTER MUST BE INSTALLED INTO THE PRINTER.
3.10BPrinter Configuration
Set the printer option switches on the Okidata ML 184T according to the tables below:
Upper Serial Board Lower Control Board
Switch Bank 1 Switch Bank 2 Switch Bank 1
1 OFF EVEN PARITY 1 ON 1 OFF
2 ON WITHOUT PARITY 2 ON 1200 BAUD 2 OFF ASCII
3 ON 8 BITS 3 OFF 3 OFF
4 ON READY/BUSY 4 OFF DSR 4 OFF
5 ON CIRCUIT/MONITOR 5 ON 32 BYTES BUFFER 5 ON
6 ON PRINT MODE 6 ON 200ms BUSY SIGNAL 6 ON AUTO LINE FEED
7 OFF 7 OFF DTR 7 ON 8 BITS
8 ON 8 OFF NOT USED 8 OFF ENABLE FRONT PANEL