User`s guide

2841 E. Industrial Drive Springfield, MO 65802-6310 800-641-4282

SCS-1 Install/User's Guide

2.7 Front and Rear Covers

Replace the front plastic cover and the two metal rear covers. The louvered rear cover mounts on top.

2.8 CRT Display

Connect the CRT Display, Keyboard, and RS-232 cable. See Sections 3.11B and 11.5. Connect the CRT to AC

power and turn on the CRT power switch. The CRT must be located adjacent to the SCS-201 Cabinet for UL Listed

operation.

2.9 Printer

Connect the printer RS-232 cable. See Section 3.10A. Install paper, connect the printer to AC power, and turn on

the printer power switch.

2.10 Start up

Apply 120 VAC to the transformer card. The 120 volts supplied to the receiver, the CRT display and the printer(s)

must be from the same UPS circuit.

2.11 Configuration

After powering up the system, set the correct time, configure the phone lines, and enter the operator codes. Refer

to Section 4 in this manual for instructions on completing the above tasks.

2 - INSTALLATION