Installation guide

SCS-1R Installation Guide Digital Monitoring Products
23
OperatOr’s Guide
SERVICE CODE
FFFFF
Service Code (XR500 Series panels)
This option allows the entry of a 5-digit service authorization code used to authenticate
service personnel before allowing access to panel programming or performing any user
operations.
Range for the 5-digit code is 00000-65535. When this feature is enabled on an XR500
Series panel and a service person enters a valid service user code for system operation
or 6653 is entered for programming at the panel, the service code entry option displays
for the service person to enter the code number programmed in this option. Once the
code is authenticated with the receiver, access to panel programming or the User Menu
is granted. If the code is not authenticated, access is denied.
The receiver cannot authenticate service personnel until a number is entered at this
option. Entering 00000 at the receiver disables this operation and access is always
granted.
Note: This panel operation is available to purchase for XR500 Series panels with version
108 or higher software. Refer to the Feature Upgrade section in the XR500 Series
Programming Guide (LT-0679) for additional information.
Host Automation
The SCS-1R programming Host Automation section allows you to make adjustments to optimize the SCS-1R
performance with the host automation computer. The display shows the current setting for each prompt. Press
any top row Select key to clear the display and enter the new information.
SCS-1R MENU
HOST AUTOMATION?
Host Automation
Press any top row Select key to program Host Automation settings. Press the COMMAND
key to advance to the next programming section. Press the Back Arrow key to return to
the System Status section.
SET TO DEFAULTS?
NO YES
Set Defaults
To set the host automation programming to the defaults, press the far right Select key
under YES.
TEST INTERVAL:
1
Test Interval
Press any top row Select key to clear the display and enter the new Test Interval. Enter
the number of minutes, 1 through 60, between communication test messages (S99)
from the SCS-1R Receiver and host computer. Default is 1 (one).
ACKNOWLEDGE
TIMEOUT: 03
Acknowledge Timeout
Press any top row Select key to clear the display and enter the new Acknowledge
Timeout. This is the time in seconds, 1 through 15, the SCS-1R waits for a host
acknowledgment of a message before transmitting it again. Default is 3 (three).
LINE NUMBER
LENGTH: 0
Line Number Length
Press any top row Select key to clear the display and enter the new Line Number
Length. Enter the number of decimal ASCII characters, 0 (zero) through 2, used to
report the SCS-1R Receiver signal line number. Default is 0 (zero).
ZONE NUMBER
LENGTH: 3
Zone Number Length
Press any top row Select key to clear the display and enter the new Zone Number
Length. Enter the number of characters, 2 through 4, used for a zone number. Default
is 3 (three).
USER NUMBER
LENGTH: 4
User Number Length
Press any top row Select key to clear the display. Enter the number of characters, 2
through 4, used for user codes. Default is 4 (four).
BAUD RATE:
9600
Baud Rate
Press any top row Select key to clear the display. Set the signaling speed between the
SCS-1R and the host computer. Baud rate is programmable for 300, 600, 1200, 2400,
4800, 9600, and 19200. Default is 9600.