User`s manual

_______________________________eBox-2300SX-LS User’s Manual

<Notice>Client computer can not remote control System Controller and Sy

stem Controller can not control Client computer. The Resolution of your

computer and Client computer should be in consistency. Otherwise, the

connection would be failed. Press CTRL+ * and the Remote control will

be finished.

 Q: How to start, set and use Terminal client Remote Control?

A: (I) Start Remote Control

a. If it is Net User Account, start Active Directory User and computer. Click fol

ders in the Control Panel Catalog, and click the user’s folder which you

want to connect.

b. If it is Computer User Account, click Computer Manage. Click “User” in

Control Panel dendriform catalog. Open “Computer Manager”/ “System Tool”/ “U

sers”. Click twice on user who you want to control. Press “Start Remote Contr

ol” and it can be work.

(II)Remote Control Default Setting

Start “Terminal Service Setting”. Press “Connect” under Control Panel. Select a

type of Remote Contrl and click right mouse key, and click “Content”. Then pr

ess “use all Remote Control Setting as below” in order to set Remote Control

which you want to connect. If you want to show message in Client Computer,

you could click “Demand Client Authority”, it means the client will know that yo

u will control and monitor their computer by the authority.

(III)Remote Control Using

Start Terminal Service Manager. Click right mouse key on a computer which yo

u want to control and monitor, and press “Remote Control”. If you want to ter

minate it, just presses CTRL+*.

<Notice>If you want to open “Terminal Service Manager”, press “Start”/

“Program”/ “System Management Tool” and press“Terminal Service Manag

er”. You must have “Completly Control” authority so that you can control

other computer. You also can use “Terminal Service Expanding” of “Acti

ve Directory User or Computer” to set every user’s Remote Control. The

Server will tell User that they are going to use Remote Control.

 Q：Terminal Service Command

A：Below is the command use in DOS.

change logon: Terminate using and loging to “Terminal” Server.

change port: Change the COM port in order to work with MS-DOS.

change user: Chage the .ini file for user.

cprofile: Remove the relation of User setting file and user designate file.

dbgtrace Start or Terminate detection or tracing.

Flattemp: Start or Terminate register.

logoff: logout from Server or user computer.

msg Send the message to user.

query process: Show the the related information of executing procesure on the

“Termianl” Server.

query session: Show the related information on “Termianl” Server.

query termserver: Show the list of all “Terminal” Server.

query user: Show the user related information on “Terminal” Server.