User`s guide

Troubleshooting

This section describes the techniques of resolving some basic problems that you encounter when

using DIN PC-333x Series. For more troubleshooting guidelines, please contact your nearest dealer

for technical support.

Troubleshooting Your DIN PC

A. DIN PC does not start

Make sure the DIN PC-333x Series is properly secured and plugged into a power source. Make

sure the power indicator shows the power is on. See section 2 for more information about “DIN

PC-333x Series Overview”.

Ensure that power connection of the DIN PC-333x Series to the external power source are

plugged in properly.

Check if your VGA or LCD monitor is properly plugged into a power source and turned on. Make

sure the brightness and contrast controls are adjusted correctly. See the manual that came with

your display (monitor) for details.

Test the outlet by connecting a different electronic device to the outlet.

Check if the DIN PC-333x Series does not function, by removing the power connection. Wait for

one minute, and then reattach the power connection.

Condensation may cause the DIN PC-333x Series to malfunction for a while. If this happens, do

not use the DIN PC-333x Series for at least one hour.

When you have checked all the above guidelines and the DIN PC-333x Series does not work.

Remove the power connection from the DIN PC-333x Series, and plug it in again. Then the

device should be powered on automatically.

B. BIOS Error Message –

BIOS error message appears when my DIN PC starts

If the BIOS error message appears, press any key to resume or, hit <DEL> to enter the BIOS setup

main menu, follow these steps:

1. Press <DEL>, and the BIOS Setup main menu appears, check if HDD is detected. If it is not

detected, use Direction keys <↑↓> to choose “AUTO” and then go back to the main menu by

pressing <ESC>. Move your cursor down with Direction keys <↓>, and choose “Save

Settings and Exit”, a message dialog appears as seen below, hit <Enter>.

“Save current settings and exit (Y/N)? Y”

2. Go to “Exit” menu using the Direction keys <↑↓> and choose the option “Load Optimal

Defaults”, then press <Enter>. A message dialog appears as seen below, hit “Y” key and

presses <Enter> to save and recover to the factory setting.

“Load Optimal Defaults (Y/N)? Y”