Software Installation Manual DMM Datalogger
Installation Procedure for DMM Datalogger Software Sections: 1. Computer Minimum Configuration 2. Setup Procedure 1. COMPUTER MINIMUM CONFIGURATION Pentium IV & Higher Processor 2 GB RAM 50MB Hard drive space CD-ROM Drive Window 7 and above USB Port (USB2.0): 1 USB Port Per Device 800 x 600 or Higher Monitor Resolution Window Supported Printer, if printout is required .NET Framework 4.0 or higher pre-installed 2.
Stage 1: Installation of Multimeter Software Fig 2. Rishabh Datalogger Step 1 Click on Next. Fig 3. Rishabh Datalogger Step 2 Now select the checkbox to create a desktop shortcut if required and click on next.
Click on Install. Fig 4. Rishabh Datalogger Step 3 Stage 2: Installation of Device Driver (FTDI CDM Driver) The setup will now ask to install USB Driver (FTDI CDM Driver). If your system has FTDI CDM Driver installed then you can skip this stage by clicking on “Cancel”. Fig 5. USB Driver Setup Click on Extract.
Fig 6. Driver Setup Step 1 Click on Next. Fig 7. Driver Setup Step 2 Click on I accept this agreement & then Click on Next. After clicking on Next button Device Driver installation start.
Fig 8. Driver Setup Finish Click on Finish to complete Device Driver Installation. Fig 9. Rishabh Datalogger Setup Finish Click on Finish to finish the installation of Complete Software. Now you can use the Software for datalogging and parameter configuration. For understanding Software features, refer the DMM Datalogger Software Manual.
