Instructions / Assembly

ASSEMBLY INSTRUCTIONS:
1.
Open your rollator. Push the folding
hinge down until it locks securely in the
straight position.
2. Place both loose hand pieces, with the
pre-assembled locking loop brakes, into
the handlebar openings and adjust to
the desired height. To do this, twist the
height adjustment knob on the outside
of each frame opening until tight.
(CAUTION: INSERT AT LEAST 2” OF HANDLEBAR
INTO OPENING TO ENSURE PROPER ALIGNMENT OF
THE HEIGHT ADJUSTMENT KNOB. HANDLE SHOULD
NOT EXCEED 40” FROM THE GROUND.)
3. Test and adjust the tension on the
braking system mechanism to ensure
proper and secure braking before use.
4. Place snap pouch onto the rollator by
placing the smaller side of the triangle
shaped pouch to the front of the rollator.
Attach the pouch by snapping the straps
around the legs on both sides of the
rollator.
5. If needed, attach basket and tray by
hooking them to the front of the rollator.
WARNING! It is very important that you read all instructions
before assembly and/or use of this rollator.
Before using the rollator, be sure your weight is within the
weight capacity of the unit. This rollator requires little assembly
and can be performed with the enclosed tool kit to adjust seat
or handles.
P
ARTS OF ASSEMBLY:
2 Handlebars with Loop Lock Brakes; 1 Snap Pouch;
1 Wire Basket; 1 Plastic Tray
INSTRUCTIONS
FOR ASSEMBLY
2
1
3
4
ITEM# 501-2014 SERIES
SPECIFICATIONS
Overall Width: 26” Wheels: 8” x 2”
Basket: 9-1/2” x 9-1/2” x 10” Pouch: 9” x 10” x 12”
Tray: 8-3/4” x 8-3/4”
Width Between Handles: 17” Handle Height: 31”
- 37”
Weight: 17 lbs. Weight Capacity: 220 lbs.