Instructions / Assembly

NOTE: No tools required.

1. Place the bamboo seat (4) upside down on a flat surface.

2. Place the legs (1&2) on the seat (legs facing up) and

align the holes on the seat with the holes on the legs.

Use the thumb screws (b) and washers (a) to secure the legs

to the seat.

3. Insert the extension legs (3) into the support legs (1&2).

Adjust the legs in 1” increments to the desired height,

and lock the pins into place.

1 - Support Leg

2 - Support Leg

3 - Extension Legs (4 included)

4 - Bamboo Seat

a - Washers (5 included)

b - Thumb Screws (5 included)

Distributed by:

Duro-Med Industries

Div. of DMS Holdings Inc.

1931 Norman Drive South

Waukegan, IL 60085 USA

www.mabisdmi.com

Made in China

Toll-Free Customer

Care Help Line

877-505-6190

#910-1704-5999 01/09

Assembly Instructions

Assembly Code

CAUTION: Make sure all thumb screws are tightened securely.

For your safety, the four extension legs must always be locked

into the same height position. All pins must be pushed

completely through the pinholes before using.

NOTE: Please call the Toll-Free Customer Care Help Line at

1-877-505-6190 if any parts are missing. Do not return to the

place of purchase.

CAUTION

This product contains natural rubber latex

which may cause allergic reactions.

PAGE 1
Assembly Instructions 3 3 3 1 a 2 b b a b a NOTE: No tools required. 1. Place the bamboo seat (4) upside down on a flat surface. b 2. Place the legs (1&2) on the seat (legs facing up) and align the holes on the seat with the holes on the legs. Use the thumb screws (b) and washers (a) to secure the legs to the seat. 3 a 3. Insert the extension legs (3) into the support legs (1&2). Adjust the legs in 1” increments to the desired height, and lock the pins into place.
PAGE 2
Asiento de Baño de Bambú Instrucciones de montaje 3 3 3 1 a 2 b b a b a NOTA: No se necesitan herramientas. 1. Coloque el asiento de bambú (4) al revés sobre una superficie plana. b 2. Coloque las patas (1 y 2) en el asiento (las patas mirando hacia arriba) y alinee los orificios del asiento con los orificios de las patas. Use los tornillos de presión (b) y las arandelas (a) para fijar las patas al asiento. 3 a 3. Inserte las patas de extensión (3) en las patas de soporte (1 y 2).