Instructions / Assembly

Parts for Assembly: Transport chair and two adjustable footrests
1. Carefully unzip the carrying case and gently pull all parts of the
Folding Transport Chair out of the bag, Fig. 1.
2. Place the folded transport chair upright as shown in Fig. 2.
3. Completely unfold the leg rigging tubes as shown in Fig. 3.
4. Halfway unfold the backrest until it is parallel with the ground Fig. 3.
NOTE: The swing down armrests may be wrapped around the brake
handles for shipping purposes. Be sure to free both armrests before
unfolding the transport chair.
5. Grasp two diagonal corners of the chair legs, and firmly pull apart,
Fig. 4. Make sure the seat is completely flat and taut.
6. Flip up the backrest, Fig. 5, and push the top of the backrest toward
the chair until the silver pins snap into the openings on the frame.
7. Firmly pull up on the armrests until they snap into the armrest
supports. Be sure the pins are completely and securely locked into
position. Repeat this step for the other armrest. NOTE: If the seat is
not completely flat and taut before attaching the armrests, you may
need to grasp the armrest with one hand and place the other hand
on the front leg. Pull up on the armrest while at the same time push
forward on the front leg as shown in Fig. 6. Be sure the spring
loaded locking pin locks into place.
8. To attach the leg riggings, squeeze the locking pins and insert the
riggings into the leg tubing. Make sure the silver pins lock into place
at the appropriate height. Repeat this step for the other leg rigging.
NOTE: The post that anchors the nylon foot strap to the footrest
should always face toward the inside of the transport chair. For your
safety, both leg riggings must always be locked into the same height
position and all pins must be pushed completely through the
pinholes before using.
9. Flip up footrests before patient sits in chair. Fasten the seatbelt and
flip down footrests. Position patient’s feet in front of nylon straps.
PARTS AND SPECIFICATIONS
501-1058-0200 Folding Transport Chair
3
IMPORTANT! Read all instructions before
assembly and/or use of this transport chair.
INSTRUCTIONS FOR ASSEMBLY
501-1058-0200
SPECIFICATIONS
Overall Width: 22-1/2”
Wheels: 7-1/2”
Handle Height: 36”
Armrest Height: 27-1/4”
Width Between Armrests: 17-1/4”
Seat: 17-1/2” x 18”
Seat Height: 19”
Weight: 20-1/2” lbs.
(with footrests)
Weight Capacity: 250 lbs.
Fig. 1
Fig. 2
Fig. 4
Fig. 5
Fig. 6
Fig. 3