User Manual

DMG | User Manual - MAXI Switch
10
1. Connect the Maxi Switch Controls (MAXI-CT-SW) to the MAXI power supply unit
(MAXI-PSU-SW) and connect the power supply to a 110VAC or 220VAC plug.
You can also input any 24VDC (min 20A) into the Maxi Switch Controls.
2. Connect the head light to its controller.
3. Turn on the MAXI Switch by selecting which power mode you want to use
(MAXI or SPLIT) with the selector.
Four modes are available :
• LOCAL MODE
• DMX MODE
• Wireless DMX MODE
• CUSTOM MODE
MAXI SWITCH USER MANUAL
LOCAL MODE :
Wireless DMX MODE :
DMX MODE:
Control the MAXI Switch remotely with the Wireless DMX
protocol
• Make sure the Wireless DMX antenna is intalled
• Press the dimmer button to enter the DMX address
of the MAXI Switch
• Validate by pressing go
Wireless DMX dot is red when no signal is received, green when the MAXI Switch
is connected to a Wireless DMX emitter.
To synchronize with a new emitter, go back to general menu and enter Wireless
DMX mode again.
Control the MAXI Switch locally with the dimmer button.
• Press the Switch button to change between CCT and
intensity control
• Press CCT button for a quick change between 3200°K
and 5600°K
• Press the dimmer button to select coarse or ne
intensity tuning
Control the MAXI Switch remotely with the cabled DMX
protocol.
CUSTOM MODE :
In custom mode the MAXI Switch acts as a translator
between different protocols. It still controls the head light
connected to it.
• Make sure the Wireless DMX antenna is intalled if
using Wireless DMX
• Make sure the Wi-Fi antenna is intalled if using Wi-Fi
• Press the dimmer button to select data input, data
output and DMX/Wireless DMX address
• Validate by pressing go
If Wi-Fi input is selected, the MAXI Switch creates a Wi-Fi network with the
following specications :
SSID: MAXI [serial number]
Password: dmglumiere
• Press the dimmer button to select the DMX address of the MAXI Switch
DMX dot is red when no signal is received, green when the MAXI Switch is
recieving DMX data.