Specifications

Controls and Operating
10
CENTER INSTRUMENT PANEL
CONTROLS – Fig. 14
Temperature Control (1)
This knob controls the temperature of the air
discharged from the vents with hotter air
being provided as the knob is turned anti-
clockwise. use this control in conjunction
with main selector switch (3) as operation of
the temperature control is only effective in
certain selector switch positions.
Fan Speed Control (2)
This knob is used to vary speed of air flow
fan. Operative only when Heater/Air
conditioner selector (3) is at off.
Main Selector Switch Positions (3)
OFF – Blower fan and air conditioning off.
Ventilation provided to foot well, defroster
and door vents.
MAX – This maximum air conditioning
setting with temperature at full cold. Set fan
speed as desired (speed 4 for maximum).
Recirculated air is supplied to face level and
door vents.
NORM – Use for refrigerated fresh air. Turn
temperature and fan speed controls to
desired position. Air conditioned fresh air is
provided to face level and door vents.
BI-LEVEL – In this position and with the
temperature control in mid-position,
conditioned air is provided to the face level
and door vents while conditioned warmer air
is provided to the footwells and a lesser
amount to the windscreen. Adjusting the
temperature control will vary the
temperature accordingly.
VENT – Fresh air at outside temperature is
supplied to the face level and door vents
with the temperature control set to full cold.
Select fan speed desired.
HEATER – Use this setting for heated air to
the footwells. Adjust temperature and fan
speed as desired. A small amount of warm
air will also be supplied to defroster and
door vents.
DEFROSTER – Main air flow is to the
defroster vents with a small amount only to
footwells and door vents. For maximum
performance turn temperature control to full
hot, fan speed to position four, close vents
at each door.
Notice:
Do not continue to run the engine with
temperature gauge registering an
excessively high reading as engine damage
may result.
When air conditioning is not in frequent use,
operate it for a few minutes each week to
lubricate compressor.