User manual

IPPC-6152A Series User Manual 50
Suspend Mode
Please refer to 3.7.3
HDD Power Down
You can choose to turn the HDD off after one of the time intervals listed,
or when the system is in Suspend Mode. If the HDD is in a power saving
mode, any access to it will wake it up.
Soft-Off by PWR-BTTN
If you choose Instant-Off, then pushing the ATX soft power switch button
once will switch the system to System Off power mode. You can
choose Delay 4 sec. If you do, then pushing the button for more than 4
seconds will turn off the system, whereas pushing the button momentarily
(for less than 4 seconds) will switch the system to Suspend Mode.
PWRON After PWR-Fail
Use this to set up the system after power failure. The "Off" will keep the
system powered off after power failure, the "On" will boot up the system
after failure, and the "Former-Sts" will return the system to the status
CPU THRM-Throttling
This field allows you to select the CPU THRM-Throttling rate. The
choices: 12.5%, 25.0%, 37.5%, 50.0%, 62.5%, 75.0%, 87.5%.
Primary IDE 0 (1) and Secondary IDE 0 (1)
When Enabled, the system will resume from suspend mode if Primary
IDE 0 (1) or Secondary IDE 0 (1) is active. The choice: Enabled, Dis-
abled.
FDD, COM, LPT PORT
When Enabled, the system will resume from suspend mode if FDD, COM
port, or LPT port is active. The choice: Enabled, Disabled.