User manual

13 Chapter 2

2.4 Installing a 2.5" SATA HDD

You can attach one enhanced Serial Advanced Technology Attachment

(SATA) hard disk drive to IPPC6152A’s internal controller which uses

PCI local bus interface. The following instructions are for installation:

1. Unscrew the back cover and open it.

2. Remove the two screws and take off CD-ROM, HDD cover.

3. Remove four screws and take off HDD bracket.

4. Insert the HDD into the bracket (see figure )

5. Put the HDD bracket into the Chassis and fasten the four screws.

6. Then attach the HDD flat cable and power cable.

7. Close the rear cover