User Manual

The TV is turned on,
but there is no picture
on the screen.
The brightness is
adjusted too low.
The fluorescent
tube is out of
order.
Adjust the brightness and the
contrast so that a picture is
displayed brightly.
The fluorescent tube of a LCD TV
has a lifetime of about 50,000
hours. To replace the fluorescent
tube, contact a service center.
An afterimage is
generated when
continuously watching
a still image.
This is caused by an inherent property of LCD panels.
Depending on the number of valid pixels, there may be
black or bright pixels. These will be less than 0.005% of
the sum of all pixels. This is not a problem.
No picture on the
screen.
No audio.
Discordance
between the
external device jack
and the input
switch button
location
Adjust the input switch location.
A picture is displayed
on the screen, but
there is no audio.
The volume is
adjusted to 0.
Mute is active.
The audio cable is
disconnected.
Turn up the Volume button.
Press the Mute button again.
Check the audio cable
connectivity.
Remote control
malfunctions.
The polarity of the
batteries installed
in the remote
control is wrong.
The batteries
installed in the
remote control
have not been
discharged
completely.
Reinstall the batteries properly.
Replace the batteries with new
ones.
Noise is heard on the
radio.
This may happen
when you use a
radio near the TV.
Noise may occur when you use a
radio near the TV. Keep some
distance between any radios and
the LCD TV.
No color in a color
picture.
The Color density is
adjusted to 0 or
almost 0.
Adjust the Color density to 100 or
le ss.
Duplicated pictures on
the screen.
This
may
be
caused
by reflected
broadcasting
signals when there
is are mountains,
buildings, or
trees
Check if there are any tall objects
such as skyscrapers near your
house.
Check that the direction of the
antenna is adjusted correctly.