User Manual

Note
After resetting, the screen goes blank and then displays a picture.
49P
Operation
Connecting to a PC
Connection Procedures
1. Connect the PC D-SUB INPUT jack of the TV and the monitor output jack of
the PC using the D-Sub cable.
2. Connect the PC AUDIO jack of the TV and the audio output jack of the PC
with the audio cable.
(This can only be applied when the PC actually has an audio output jack.)
Procedures for viewing the PC screen through the TV
1. Turn the PC on and check that the PC settings are correct.
? If the PC settings are incorrect, the screen may display a duplicated or distorted picture.
? For PC configuration procedures, refer to page 54.
2. Press the TV/SOURCE button and select PC IN PUT mode.
Else you can press the PC button on the remote control instead.
3. Adjust the PC screen.
(For adjustment procedures, refer to page 55~59.)
50P
Operation
Configuring a PC
The following PC screen configuration procedures may differ depending on the model of
your PC. This product supports DDC (Display Data Channel) to enable the automatic
configuration of the screen.
PC Configuration Procedures
1.