User Manual

4. Select AIR, STD, HRC, or IRC using the 「CHANNEL?/?」button.

If you are not sure which type of cable system you have, contact your cable company.

Note: STD, HRC and IRC represent various types of cable TV systems.

24P

Procedures for Using the TV

Storing Channels in Memory (Automatic Method)

The TV automatically runs through all available channels and stores them to memory. This

takes approximately one or two minutes.

First, select the correct signal source (AIR, STD, HRC, IRC). See steps 1~4 on the

previous page.

Note: The auto channel program does not function when the V-chip is active.

2. Select AUTOSEARCH using the「CHANNEL?/?」button and then press the

「VOL+」button.

The TV will begin storing all available channels.

After all available channels have been stored, the AUTOSEARCH menu reappears.

3. Press the 「

EXIT

」

button to exit the menu

Viewing Saved Channels

Press the 「CHANNEL?/?」button.

? Only saved channels are selected.

? The AUTO MEMORY function can select channels using the 「CHANNEL

?/?」button only when more than 3 channels have been saved.

25P

Procedures for Using the TV

Adding and Erasing Channels (Manual Method)

You can use this function to add channels and to delete unwanted channels after the auto

channel configuration.

1.Press the 「MENU」button.