User Manual

Press the DISPLAY button on the remote control. The TV will display the input source, the
picture mode, the sound mode, the mts mode, the current time, the v-chip and the audio
signal you are listening to.
Adjusting the Volume
? Adjust the volume using the 「-VOL/VOL+」button.
Muting the Sound
? Press the「MUTE」button.
You can conveniently use the MUTE button when a telephone or a door bell rings.
To cancel, press the MUTE button again.
Viewing a Video or DVD
? Press the「TV/VIDEO」button.
For connection and setup procedures, refer to page 14~15.
23P
Procedures for Using the TV
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna)
and cable channels. After the available channels are memorized, use the CHANNEL? and
CHANNEL? buttons to scan through the channels. This eliminates the need to change
channels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic) and adding and deleting
channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the
type of signal source that is connected to the TV (i.e., an antenna or a cable system).
1. Press the 「MENU」button.
The OSD MENU will be displayed.
2. Select CHANNEL SETUP using the「CHANNEL?/?」button and then press
the 「VOL+」button.
3. Select ANTENNA using the「CHANNEL?/?」button and then press the
「VOL+」button.