Specifications

9
3. Two subwoofers bridged to XM40.
Filter settings front channels CH 1 / 2
Speaker wiring XM40
Filter settings rear channels CH 3 / 4
XM40
For power wiring, see page 3-4
For high or low level input wiring, see page 4
One 4 ohm subwoofer connected to channels 1 / 2
and one 4 ohm subwoofer to channels 3 / 4.
The low pass filter (LPF) is
mostly used for subwoofers. It
will allow low frequencies only
and blocks higher frequencies.
A typical setting is 60 – 70 Hz.
Set the switch to LPF position to activate the filter.
Use this position when conncted to a subwoofer.
+ CH3 - + CH4 -
+ CH1 - + CH2 -
4 ohm
+ -
50 Hz 500 Hz
HPF FULL LPF
LPF FILTER
4 ohm
+ -
BRIDGEABLE
BRIDGEABLE