Specifications

XM10
Speaker wiring XM10
Two 4 ohm subwoofers
One 4 ohm or 2 ohm subwoofer
6
NOTE!
Two 4 ohm subwoofers gives a 2 ohm load when
sonnected in this way.
Minimum amplifier load is 2 ohm, lower impedan-
ces may damage the amplifier.
NOTE!
Subwoofer impedance can be 4 ohm or 2 ohm.
Minimum amplifier load is 2 ohm, lower impedan-
ces may damage the amplifier.
CONNECTIONS IN SERIES OR PARALLEL
Subwoofers with dual voice coils, or any subwoo-
fer, can be connected in series or in parallel for
various impedances but the resulting impedance
must never be lower than 2 ohm.
Filter settings Low Pass filter
+ + - -
- +
- +
- +
The low pass filter is most-
ly used for subwoofers. It
will allow low frequencies
only and blocks higher
frequencies.
A typical setting is 60 –
70 Hz.
Set the switch in LPF position to activate the filter.
Set the switch in FULL position if you want to run
the amplifier in full range mode.
50 Hz 200 Hz
LPF
FILTER
FULL LPF
You can adjust the bass sound level from the
front seat of your car if you connect the external
sub level control box.
Connect to REM socket.
Remote sub level control
+ + - -