Technical data

TECHNICAL REFERENCE MANUAL
No. Action Comment Command
5
Save settings The changed configuration must be
saved to make it permanent.
Example for module 0:
Save settings for module 0
s0s<trm>
1)
6
Set automatic mode Set the DLS-A(H) to the automatic
mode with the desired update rate.
Example for module 0:
Set measurement rate to fastest
possible speed.
s0A+0<trm>
1)
1) Commands are described in 8 Command set on page 19
Remark: If the serial line settings of the module have been lost, please reset the configuration to the factory
settings (7 Factory settings on page 18) using the reset button (5.2 Reset switch on page 15). Please
note that the ID switch must be reset manually.
Distance Laser Sensor Page 9/40