Technical data

TECHNICAL REFERENCE MANUAL
8.3.7 Save configuration parameters (sNs)
This command saves all configuration parameters, which are set by the commands above. The parameters are
written to the Flash Memory.
Command input:
sNs<trm>
N:
Module number (0..9)
Return data:
Successful:
gNs?<trm>
Error: gN@Ezzz
zzz:
Error code
8.3.8 Set configuration parameters to factory default (sNd)
This command restores all configuration parameters to their factory default values. The parameters are written
to the Flash Memory.
)
The communication parameters are also reset to factory settings.
Command input:
sNd<trm>
N:
Module number (0..9)
Return data:
Successful:
gN?<trm>
Error: gN@Ezzz
zzz:
Error code
8.3.9 Get software version (sNN00N)
Retrieves the software version of the DLS-A(H).
Command input:
sNN00N<trm>
N:
Module number (0..9)
Return data
Successful:
gNN00N+vvvvxxxxyyyy<trm>
vvvv:
Interface software version
xxxx: Board version number
yyyy: SW version number
Error:
gN@Ezzz<trm>
zzz:
Error code
Distance Laser Sensor Page 25/40