Specifications

Example 9:
System with P-300X, 5-channel amplifier with a front 2-way system
with active crossover and a subwoofer.
Tweeters
Midrange/bass
Subwoofer
/ woofers
Ch1
Ch5
Example 10:
System with P-300X, front system, "rear fill", and a subwoofer.
LP-filter
LP-filter
Ch1
Ch2
Ch3
Ch4
Ch5
Subwoofer using the built-
in filters of the amplifier.
In
P-300X
In
In
P-300X
In
In
In
A single line input is
often enough in this
application.
21
P-300X
In
In
In
Ch5
Ch3
Ch4
Ch2
Ch1
Front system connected in
bridge mode to channel 1 - 4.
The speakers own filters are
used in combination with the
built-in filters in the amplifier.
(Adjust the ch 3-4 lowpass
filter to 40 kHz x-over freq.)
Subwoofer is using the ch 5
built-in filters.
Subwoofer using the
amplifiers built-in filters
Example 11:
System with P-300X. Front system connected in bridge mode to ch. 1 -
4. subwoofer to ch 5.
Front 2-way
system
incl. filter
"rear fill"
speakers
In this example the
speakers own passive
filters are used to the
front system in
combination with the
built-in highpass filters
on channel 1-2.
On channel 3-4 är "rear
fill" speakers are
connected. the
amplifiers built-in filters
are used.
The sub also uses the
built-in filters.
L+
L-
L+
R+
R-
L-
R+
R-
LP-filter
LP-filter
+
-
With two line inputs it is
possible to adjust the
balance between front and rear
speaker systems.
L+
L-
R+
R-
L+
L-
R+
R-
+
-
If you want to
balance the
front/rear level
you must add
a line-in to the
sub input on
channel 5.
Ch2
R-
R+
Ch4
Ch3
L-
L+
R-
R+
+
L+
L-
-
Channel 1 & 2 = Tweeters with active high-pass filter
Channel 3 & 4 = Midrange with high- and low-pass filter
Channel 5 = Subwoofer with low-pass filter
No passive crossovers are needed. The built-in active
filters are used to all speakers.
Connect the inputs in
parallell with Y-adaptors
DLS SOUND HANDBOOK - GENESIS WIRING EXAMPLES