Specifications

Example 7:

System with a 4-channel amplifier, front and rear system, subwoofers and a

center channel speaker.

In this system you can use DLS DQ/Ref 200, GENESIS Q-100X, Q-200X, Compact Four or Four Channel.

All these amplifiers have built-in electronic crossovers.

A center-channel speaker is connected i multimode. The center-channel level can be adjusted with a

variable resistor.

Car stereo

Center channel

speaker

0,15 mH

R = 0-20

Ω

Tweeters

with filter

Front system

L-

R- R+

Lp-filter

L+ L- R- R+

L+

Ω

Suitable for: All DLS and GENESIS 4-channel amplifiers.

Passive x-overs: A center channel speaker is connected in bridge mode. To adjust the level you need a

variable resistor with 15 watts power handing capacity. A band-pass filter allows the speaker to reproduce

frequencies between 550 to 6000 Hz.

Active filters: The built-in filters are used.

Amplifier load: FRONT: 1,3 ohms

REAR: 2 ohms in the example above.

1,75 mH

4,7

DLS SOUND HANDBOOK - AMPLIFIER WIRING EXAMPLES

4-channel amplifiers

NOTE! The subwoofers must never form an impedance lower than 4 ohms.

The mono bridge mode

connected sub should

have an impedance of 4

ohms.