System information

Program 10 : System Configuration Setup
10-31 : Networking Keep Alive Setup
UX5000 Software Program Manual Programming ◆ 83
Conditions
The keep alive message must be sent and a response not received for the retry count, for the link to
be taken out of service and the calls in progress and Park Hold orbits to be released.
For example: If an ISDN CygniLink connection is disconnected at Layer 1 then the keep alive mes-
sage can not be sent, therefore the keep alive operation will not occur.
Feature Cross Reference
Networking - AspireNet
Terminal Programming Instructions
To enter data for Program 10-31 (Networking Keep Alive Setup):
1. Enter the programming mode.
2. 10 31
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press MIC once to enter a new item number.
OR
Press MIC until you’ve exited that series’s programming section.
10-31-01
Interval 0 Sec.
back
↑ ↓ select
10-31-nn
nnnnn
← →