System information

Program 10 : System Configuration Setup
10-31 : Networking Keep Alive Setup
82 ◆ Programming UX5000 Software Program Manual
10-31 : Networking Keep Alive Setup
Description
Use Program 10-31 : Networking Keep Alive Setup to set the interval and retry count of the
AspireNet networking keep alive message. The keep alive is used for ISDN and IP networking.
The keep alive message is automatically responded to by the destination UX5000, if the response is
not received the retry count will start. If a response is not received within the number of retries the
networking link will be taken out of service. When the link is taken out of service:
● Any calls that are in progress will be released.
● Park Hold orbits will be released.
● No further Park Hold information will be sent until the link is active.
The link will automatically become active when the next keep alive response is received.
Input Data
Level:
Feature Availability
IN • Available.
Item
No.
Item Input Data Default
Related
Program
01 Keep Alive Interval
This program is used to set the inter-
val of Keep Alive. The UX5000
does not send Keep alive when this
item is set to "0".
If this entry is greater than “0”, net-
worked PRI spans which are using
Kentrox DSUs will not re-sync
when removed from service then
returned to service.
0-65535 seconds 0
02 Keep Alive Retry Timer
Set how many times the UX5000
resends Keep Alive.
1-255 5
03 Time Synchronization
The time signal is transmitted at
0:00 to all UX5000s every day
when this option is set. When the
signal is received, the slave or mas-
ter (depending on the programmed
option) of the same period of time
corrects its time to 0:00.
0 = No Time Syn-
chronization
1 = Synchroniza-
tion Master
2 = Synchroniza-
tion Slave
0