System information

Program 90 : Maintenance Program
90-05 : Slot Control
UX5000 Software Program Manual Programming ◆ 921
90-05 : Slot Control
Description
Use Program 90-05 : Slot Control to reset, delete (uninstall), block or release block for circuit
boards (slots 1-24).
Delete allows you to completely uninstall the blade. You might want to do this if you want to
remove a blade and plug it into a different slot - and still retain the port assignments. If a different
type of interface card is being installed into a slot previously used (example; changing from a COIU
to an ESIU blade), the slot should be deleted (option 1) first before installing the new interface card.
Reset allows you to send a reset code.
This program is also used when you wish to block traffic on a blade. This would be used when you
wish to remove a blade from the UX5000. Blocking the blade allows active users on the blade to
complete their call, but prevents and new users from seizing the extension/trunk on that blade. Be
sure to release the block once the blade can be used.
Input Data
Conditions
● When you delete or reset a blade, you must first remove it from its slot then run Program
90-05. When reusing the slot for another blade, you must plug the blade in or reset the
UX5000 before the UX5000 will use the slot again.
● When a blade is switched to another slot, first remove the blade and delete it using this pro-
gram. Prior to plugging the blade into its new slot, reset the UX5000. Without resetting the
UX5000, there may be issues with port assignment for the blade.
● This program is only available in terminal and WebPro programming.
Feature Cross Reference
None
Level:
Feature Availability
IN • Available.
System ID 00-50
Menu Number 1 = Delete
2 = Reset
3 = Set Block (Set Busy Out)
4 = Release Block (Reset Busy Out)
Item No. Item Input Data
01 Slot Control Slot Number (0-24)