System information

Program 84 : Hardware Setup for VoIP
84-25 : CygniLink Codec Information Basic Setup
UX5000 Software Program Manual Programming ◆ 905
Conditions
When any of these program options are changed, the VOIPD will be reset automatically. The
UX5000 will allow any active calls to finished and it will prevent any new resources from being
secured until the card is reset.
Feature Cross Reference
● VoIP
38 G.726 Audio Frame
Maximum number of G.726 Audio Frames. G.726 assumes the
audio signal made by a specimen by 16kHz and the frame of 10ms
is assumed to be a unit to 32kbps by the encoding compressed
method.
1 = 10 ms
2 = 20 ms
3 = 30 ms
4 = 40 ms
3
39 G.726 Silence Compression Mode
Select whether to compress silence with G.726. When there is
silence, the RTP packet is not sent.
0 = Disable
1 = Enable
0
40 G.726 Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of G.726 is set. Jitter is
the variation in the time between packets arriving and the buffer
allows this variation to be absorbed.
0-160 ms 30
41 G.726 Jitter Buffer - Standard
Set the average G.726 Jitter Buffer.
0-160 ms 60
42 G.726 Jitter Buffer - Maximum
Set the maximum G.726 Jitter Buffer.
0-160 ms 120
43 iLBC Audio Frame
Maximum number of iLBC Audio Frames. iLBC assumes the
frame of 10ms is a unit.
2 = 20 ms
3 = 30 ms
4 = 40 ms
3
44 iLBC Silence Compression Mode
Select whether to compress silence with iLBC. When there is
silence, the RTP packet is not sent.
0 = Disable
1 = Enable
0
45 iLBC Jitter Buffer - Minimum
Set the minimum value of the Jitter Buffer of iLBC is set. Jitter is
the variation in the time between packets arriving and the buffer
allows this variation to be absorbed.
0-160 ms 30
46 iLBC Jitter Buffer - Standard
Set the average iLBC Jitter Buffer.
0-160 ms 60
47 iLBC Jitter Buffer - Maximum
Set the maximum iLBC Jitter Buffer.
0-160 ms 120
48 ILBC Payload Number
Set the payload number of iLBC. This entry cannot be the same
number as Item 31.
96-127 98
Item No. Item Input Data Default