System information

Program 84 : Hardware Setup for VoIP
84-01 : Codec Information Basic Setup
UX5000 Software Program Manual Programming ◆ 843
51 Fax Relay: Scan Line Fix Up Feature 0 = Disable
1 = Enable
1
52 Fax Relay: Eflags for First DIS 0 = Disable
1 = Enable
1
53 Fax Relay: FOP Protocol Enhancement 0 = Disable
1 = Enable
1
54 Fax Relay: NSF Override 0 = Disable
1 = Enable
0
55 ECM (Error Correction Mode) 0 = Disable
1 = Enable
1
56 MR (Modified Read) Page Compression 0 = Disable
1 = Enable
1
57 NSF Country Code
Fax Relay - NSF Override Disable
0-65535 0
58 NSF Vendor Code
Fax Relay - NSF Override Disable
0-65535 0
59 Fax Relay Function
Determine whether or not the Fax Relay function should be used.
With the terminal type set to “1” in Program 15-03-03, Each Port Mode
can be used. The fax relay is executed only for a single terminal, S-Bus,
trunk or the special network.
0 = Disable
1 = Enable
2 = Each Port Mode
0
60 Echo Canceller Config Type
The type is defined in Program 84-17.
• 0: Automatic
If the call is analog (e.g. COIU or 2-wire tie line) then this selects the
echo canceller profile configured in Program 84-17 Type 4 (“Analog
Path Setting”). Any other call selects the echo canceller profile con-
figured in Program 84-17 Type 5 (“Digital Path Setting”). Note that
the 4-wire tie line is treated as digital.
• 1: Type 1
This selects the echo canceller profile configured in Program 84-17
Type 1.
• 2: Type 2
This selects the echo canceller profile configured in Program 84-17
Type 2.
• 3: Type 3
This selects the echo canceller profile configured in Program 84-17
Type 3.
0 = Auto
1 = Type 1
2 = Type 2
3 = Type 3
0
61 Echo Auto Gain Control 0 - 5 0
62 H.323 DTMF Payload Number
Define the H.323 DTMF Payload Number.
With the DTMF mode set to 0, the set-up information set by 84-06-10 is
used for the VOIPDB. This option gives priority if set to either of 1, 2, 3.
0 = VOIPDB
1 = RFC2833
2 = H.245
3 = Disable
0
Item
No.
Item Input Data Default