System information

Program 47 : IntraMail
47-02: IntraMail Station Mailbox Options
698 ◆ Programming UX5000 Software Program Manual
08 Message Waiting Lamp
(Update MW Lamp)
Use this option to enable or disable Message Waiting lamping
at the extension associated with the Subscriber mailbox. For
Subscriber Mailboxes, you should leave this option enabled.
For Guest Mailboxes, you should leave this option disabled.
1 (Yes - enabled)
0 (No - disabled)
1 (Yes -
enabled)
09 Auto Attendant Do Not Disturb
(Auto-ATT DND)
Use this option to enable or disable Auto Attendant Do Not
Disturb. When a subscriber enables Auto Attendant Do Not
Disturb, an Automated Attendant caller will route directly to
the mailbox, hear the greeting, and be asked to leave a message.
1 (Yes - enabled)
0 (No - disabled)
0 (No -
disabled)
10 Forced Unscreened Transfer
(Forced UTRF)
Use this option to enable or disable Automated Attendant Forced
Unscreened Transfer for the Subscriber Mailbox. If enabled, each
Screened Transfer (TRF) to the extension is converted to an
Unscreened Transfer (UTRF). If disabled, Screened Transfers
from the Automated Attendant occur normally.
1 (Yes - enabled)
0 (No - disabled)
0 (No -
disabled)
11 Auto Time Stamp
(Auto Time Stamp)
Use this option to enable or disable Auto Time Stamp for the
Subscriber Mailbox. If enabled, after the subscriber listens to a
message IntraMail will announce the time and date the message
was left. Auto Time Stamp will also announce the message
sender (if known).
A subscriber can also enable Auto Time Stamp from their mail-
box.
1 (Yes - enabled)
0 (No - disabled)
0 (No -
disabled)
12 System Administrator
(System Admin)
Use this option to designate the Subscriber Mailbox as a Sys-
tem Administrator. This allows the subscriber to use the
SA
options after logging onto their mailbox.
1 (Yes - enabled)
0 (No - disabled)
Mailbox 1
(301) =
Enabled (1)
All other
mailboxes =
Disabled (0)
13 Dialing Option
(Dialing Option)
Dialing Option provides additional dialing options for Next
Call Routing Mailbox calls (see Next Call Routing Mailbox
below). If enabled, a caller who accesses the Subscriber Mail-
box to leave a message can dial any of the options in the Next
Call Routing Mailbox’s Dial Action Table. If disabled, the
caller can only dial 0 (to use the Next Call Routing Mailbox’s 0
action).
1 (Yes - enabled)
0 (No - disabled)
0 (No -
disabled)