System information

Program 45 : Voice Mail Integration
45-01 : Voice Mail Integration Options
684 ◆ Programming UX5000 Software Program Manual
Conditions
None
05 Message Wait
Enable/disable the UX5000’s ability to pro-
cess the Voice Mail’s Message Wait (#)
commands. You should normally enable
this option. If enabled, be sure that the pro-
grammed Message Notification strings
don’t contain the code #9 for trunk access.
When using the voice mail’s Dial Action
Table external transfers (ex: to an Abbre-
viated Dial number), this setting must be
set to “0” (off).
0 = Off
1 = On
1 45-01-13
06 Record Alert Tone Interval Time
This timer sets the interval between voice
Mail Conversation Record alerts
0-64800 seconds 30
07 Mailbox Number
Enter the extension number of the voice
mail to be accessed as the centralized voice
mail unit when the CygniLink feature is
used.
Up to 8 Digits -
08 Networked Voice Mail Department
Group Number
Assign which Extension (Department)
Group number is to be assigned as the voice
mail group with a networked system. An
entry of ‘0’ means there is no voice mail
installed.
0 - 64
(0=no voice mail)
0
09 Networked Voice Mail Master Name
Enter the Voice Mail master name
(networked system).
Up to 12 Characters C.V.M.
10 NSL Protocol Support
This option must be enabled (1) in order for
the display to use the NSL protocol.
0 = NSL Protocol Disabled
1 = NSL Protocol Enabled
0
16 Digit Add Assignment for SLT
Assign up to four digits in front of the sta-
tion number sent to the Special SLT Port
when a call is forwarded.
Assign the leading digits (up to 4) to show
in front of extension numbers on forwarded
calls sent to analog ports defined as "1" in
Program 15-03-16 (Special DTMF Protocol
Sent). If this entry is blank and Program
15-03-16 is enabled, the protocol will only
include the extension number. (Entries: 0 -
9, # *)
Dial (Up to 4 Digits) No Setting 15-03-16