System information

Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
UX5000 Software Program Manual Programming ◆ 669
Conditions
None
Feature Cross Reference
● Automatic Route Selection (ARS)/F-Route
Terminal Programming Instructions
To enter data for Program 44-02 (Dial Analysis Table for ARS/F-Route Access):
1. Enter the programming mode.
2. 44 02
3. Enter the number of the item you want to program.
4. Enter the Analyze Table number to be defined or press FLASH to use the displayed entry.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press MIC once to enter a new item number.
OR
Press MIC until you’ve exited that series’s programming section.
03 Additional Data
For the Service Type selected in 44-02-02, enter the addi-
tional data required.
• 1: Delete Digit = 0-255 (255=delete all digits)
• 2: [Program 44-01 : 0]
ARS/F-Route Table Number = 0-500 (0=No setting)
Refer to Program 44-05.
[Program 44-01 : 1]
ARS/F-Route Select Table Number = 0-500 (0=No setting)
Refer to Program 44-04.
• 3: Dial Extension Analyze Table Number = 0-4
(0=No setting)
Refer to Program 44-03.
• 1: Delete Digit = 0-255
(255 : delete all digits)
• 2: 0-500 (0=No setting)
• 3: Dial Extension Analyze
Table Number = 0-4 (0=No
setting)
0
04 Dial Tone Simulation
If enabled, this option sends dial tone to the calling party once
the routing is determined. This may be required if the central
office at the destination does not send dial tone.
0=off
1=on
0
44-02-01 Analyze TBL1
Dial
back
↑ ↓ select
44-02-nn Analyze TBLnnn
nnnnn
← − + →
Item No. Item Input Data Default