System information

Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
668 ◆ Programming UX5000 Software Program Manual
44-02 : Dial Analysis Table for ARS/F-Route Access
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access to set the Pre-Transaction
Table for selecting ARS/F-Route.
Input Data
Level:
Feature Availability
IN • Available.
Dial Analysis Table Number 1-120
Item No. Item Input Data Default
01 Dial
Set the number of digits to be analyzed by the UX5000 for
ARS routing.
Up to 8 digits
(Use line key 1 for a “Don’t Care”
digit, @)
No
setting
02 Service Type
• Service Type 1 (Extension number)
The number goes to an extension after deleting the front
digit(s).
Additional data
Assign the digit(s) to be deleted on top of the number for
extension number usage. There must be at least one digit
deleted.
• Service Type 2 (ARS/F-Route)
The number is controlled by ARS/F-Route table.
Additional data
If the ARS/F-Route Time Schedule is not used, assign the
ARS/F-Route table number for Program 44-05.
If the ARS/F-Route Time Schedule is used, assign the
ARS/F-Route selection number for Program 44-04.
• Service Type 3 (Dial Extension Analyze Table)
The total length of the number exceeds more than 8 digits.
Additional data
Assign the Dial Extension Analysis Table number to be
used in Program 44-03.
0=No setting
1=Extension Call
2=ARS/F-Route Table
3=Dial Extension Analyze Table
0