System information

Program 35 : SMDR and Account Code Setup
35-02 : SMDR Output Options
584 ◆ Programming UX5000 Software Program Manual
11 Walking Toll Restriction Table Number
- Not Used -
0=Not Displayed
1=Displayed
1
12 DID Table Name Output
Determine if the DID table name should be displayed.
0=Not Displayed
1=Displayed
0
13 CLI Output When DID to Trunk
Determine if the CLI output should be displayed for DID.
0=Not Displayed
1=Displayed
14 Date
Determine whether the date should be displayed on SMDR reports.
This option must be set to “0” if the trunk name is set to be displayed
in Program 35-02-03.
0=Not Displayed
1=Displayed
0
15 CLI / DID Number
Determine if the CLI/DID Number should be displayed.
Caller ID Name (2) requires software 4.0E+.
0=Caller ID Number
1=DID Calling
Number
2=Caller ID Name
0
16 Trunk Name or Received Dialed Number
Determine which should be displayed for an incoming call - the trunk
name as assigned in Program 14-01-01 (0), the received dialed number
(1), or both (2). If set to (1), ANI/DNIS trunks can print DNIS digits.
For DID trunks, if the received number is not defined in Program
22-11-01, then no number will be printed. If both (2) is selected, the
SMDR detail will show the 3 characters of the trunk name, followed by
the last 6 digits of the received dialed number.
0=Trunk port name
1=Received dialed num-
ber
2=Both
0
17 Print Account Code or Caller ID Name
Determine whether the Account Code or Caller ID name should appear
in the SMDR record.
Note: Program 35-01-08 must be set to "0" for this entry to be fol-
lowed.
0=Acount Code
1=Caller ID Name
0
18 Caller ID Name Output Method
Select whether to display up to 16 characters of the Caller ID Name on
the same line as the call record or if a line feed should be added and up
to 24 characters of the Caller ID Name will be displayed on the follow-
ing line. If the line feed option is selected, the Caller ID Name will be
displayed on the next line as : NEXT "Caller ID Name".
This setting will work regardless of the setting in Program 35-02-15.
Note: With this option set to "1", if your communications program
(such as HyperTerminal) has the line wrap option enabled in the ASCII
setup, an additional line break may appear above the Caller ID name
line.
0=Same Line
1=Line Feed Prior to
Caller ID
0
19 Dialed Number Output Format
Determine if the dialed number should display the first 20 digits or the
last 20 digits. This option is only available for outgoing calls.
0=First 20 Digits
1=Last 20 Digits
0
Item
No.
Item Input Data Default