System information

Program 34 : Tie Line Setup
34-09 : ANI/DNIS Service Options
576 ◆ Programming UX5000 Software Program Manual
04 Route Table Setup of Target Dial
The option sets how the UX5000 uses the
route data (gathered in Item 3) to route incom-
ing ANI/DNIS calls).
If option ‘2’ is selected and the call is to be
routed using the DID table (1), up to 8 digits
can be matched. The number of expected dig-
its set in Program 22-09-01 must match the
ANI digits defined in Program 22-11-01. For
example, if an ANI/DNIS number received
was *2035551234*3001* and Program
22-09-01=4, then the entry in 22-11-01 must
be 1234 with the defined target extension.
If the call is to be routed using the ABB table
(0), up to 24 digits can be matched. Define the
range of the ABB table to be used in Program
34-09-06. The data is then compared to the
entries in Program 13-04-01 and then routed
according to Program 13-04-03.
0 = ABB Table
(Program 13-03)
1 = DID Table
(Program 22-11)
0 0 13-04-01
13-04-03
22-09-01
22-11
34-09-05
34-09-06
05 ANI/DNIS Display as Target Dial Name
Use this option to set if ANI data should
appear on terminal displays as part of Caller
ID display.
0 = Display Off
1 = Display On
1 0 13-04
20-09-02
22-11-03
23-09-04
06 Routing ABB Table Setup
Use this option to define which part of the
ABB Table set up in Program 13-04 the
UX5000 will use for ANI/DNIS Caller ID
look-ups and ANI/DNIS routing.
This is required if Items 4 and 5 above are 1
(Caller ID on). When you specify a starting
and end address, the UX5000 uses the part of
the table for look-ups.
When you specify a starting address and
length, the UX5000 uses that part of the table
for routing. If the incoming ANI/DNIS num-
ber data matches the Number entry in the
table, the UX5000 routes according to the
associated Name data. That data can be an
extension, Department Group pilot number,
the voice mail master number or a trunk ring
group.
Start = 0, 100-1900
End = 0, 99-1999
Start = 1000
End = 1199
Start = 0
End = 0
13-04
07 Routing on ANI/DNIS Error
This option lets you determine how the
UX5000 will handle an ANI/DNIS call if a
data error is detected in the incoming data
string.
0 = Play busy tone to
caller
1 = Route the caller to
the ring group speci-
fied in Program 25-03
1 0 25-03
Item
No.
Name Input Data
Default
Related
Program
COS 01-14 COS 15