System information

Program 34 : Tie Line Setup
34-03 : Trunk Group Routing for E&M Tie Lines
564 ◆ Programming UX5000 Software Program Manual
Terminal Programming Instructions
To enter data for Program 34-03 (Trunk Group Routing for E&M Tie Lines):
1. Enter the programming mode.
2. 34 03
3. Enter the number of the item you want to program.
4. Enter the trunk port number to be defined or press FLASH to use the displayed entry.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press MIC once to enter a new item number.
OR
Press MIC until you’ve exited that series’s programming section.
34-03-01 Trk Port 1
Mode1 Route_Table1
back
↑ ↓ select
34-03-nn Trk Port nnn
nnnnn
← − + →