System information

Program 10 : System Configuration Setup
10-12 : CCPU Network Setup
UX5000 Software Program Manual Programming ◆ 41
Conditions
The UX5000 must be reset in order for these changes to take affect.
07 Default Gateway (WAN Side)
IP Address
Set the Default Gateway’s IP
Address. With SIP trunking, the IP
address of the WAN side of the
router must be entered.
0.0.0.0 - 126.255.255.254
128.0.0.1 - 191.255.255.254
192.0.0.1 - 223.225.225.254
0.0.0.0
08 ICMP Redirect
When the UX5000 receives the
ICMP REDIRECT message, deter-
mine whether the IP routing table is
automatically updated.
0=Enable (Update Automatically)
1=Disable (No Automatic Update)
0
09 VoIP Daughter Board IP Address
Set the LAN IP address for the 32,
64 and 128 channel VoIP daughter
boards. The IP number increases by
one for each increase in the slot
number.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 -191.255.255.254
192.0.0.1 ~ 223.255.255.254
172.16.0.10
10 VoIP Daughter Board Subnet
Mask
Define the subnet mask for the 32,
64 and 128 channel VoIP daughter
boards. The setting of Subnet Mask
errors when all Host Addresses are
0.
If the network section is:
0,
127
128.0
191.255
192.0.0
223.255.255
The setting of Subnet Mask errors.
128.0.0.0
240.0.0.0
254.0.0.0
255.192.0.0
255.248.0.0
255.255.0.0
255.255.224.0
255.255.252.0
255.255.255.128
255.255.255.240
255.255.255.254
192.0.0.0
248.0.0.0
255.0.0.0
255.224.0.0
255.252.0.0
255.255.128.0
255.255.240.0
255.255.254.0
255.255.255.192
255.255.255.248
255.255.255.255
224.0.0.0
252.0.0.0
255.128.0.0
255.240.0.0
255.254.0.0
255.255.192.0
255.255.248.0
255.255.255.0
255.255.255.224
255.255.255.252
255.255.0.0
11 VoIP Daughter Board NIC
Define the NIC setting for the VoIP
daughter board. With auto negotiate,
the destination sets the ability (from
1-4) based on the ability of the con-
nected device.
0 = Auto Detect
1 = 100Mbps, Full Duplex
2 = 100Mbps, Half Duplex
3 = 10Mbps, Full Duplex
4 = 10Mbps, Half Duplex
0
12 VoIP Daughter Board ICMP
Redirect
When the UX5000 receives the
ICMP REDIRECT message, deter-
mine whether the IP routing table is
automatically updated for the 32, 64
and 128 channel VoIP daughter
boards.
0=Enable (Update Automatically)
1=Disable (No Automatic Update)
0