System information

Program 10 : System Configuration Setup
10-12 : CCPU Network Setup
40 ◆ Programming UX5000 Software Program Manual
10-12 : CCPU Network Setup
Description
Use Program 10-12 : CCPU Network Setup to setup the IP Address, Subnet-Mask, and Default
Gateway addresses of the CCPU and EXIFU.
Input Data
Level:
Feature Availability
SA • Available.
Item
No.
Item Input Data Default
01 IP Address
Set the IP address for the CCPU.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 -191.255.255.254
192.0.0.1 ~ 223.255.255.254
Slot 1:
192.168.0.10
Slot 4:
192.168.0.13
02 Subnet Mask
The setting of Subnet Mask errors
when all Host Addresses are 0.
If the network section is:
0,
127
128.0
191.255
192.0.0
223.255.255
The setting of Subnet Mask errors.
128.0.0.0
240.0.0.0
254.0.0.0
255.192.0.0
255.248.0.0
255.255.0.0
255.255.224.0
255.255.252.0
255.255.255.128
255.255.255.240
255.255.255.254
192.0.0.0
248.0.0.0
255.0.0.0
255.224.0.0
255.252.0.0
255.255.128.0
255.255.240.0
255.255.254.0
255.255.255.192
255.255.255.248
255.255.255.255
224.0.0.0
252.0.0.0
255.128.0.0
255.240.0.0
255.254.0.0
255.255.192.0
255.255.248.0
255.255.255.0
255.255.255.224
255.255.255.252
255.255.255.0
03 Default Gateway
IP Address for Router
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0
04 Time Zone
Enter the difference for standard
time.
0 ~ 24 (-12 thru +12 Hours) 7 Hours
05 NIC
NIC Auto Negotiate
0 = Auto Detect
1 = 100Mbps, Full Duplex
2 = 100Mbps, Half Duplex
3 = 10Mbps, Full Duplex
4 = 10Mbps, Half Duplex
0
06 NAT Router Setup
Enable or disable the NAPT Router
Setup. With SIP trunking behind a
NAPT router, this must be set to
enabled.
0=Disable, 1=Enable 0