System information

Program 10 : System Configuration Setup
10-08 : Pre-Ringing Setup
UX5000 Software Program Manual Programming ◆ 37
10-08 : Pre-Ringing Setup
Description
Use Program 10-08 : Pre-Ringing Setup to enable or disable pre-ringing for trunk calls. This sets
how a trunk initially rings a terminal. With pre-ringing, a burst of ringing occurs as soon as the
trunk’s LED fl ashes. The call then continues ringing with the normal ring cadence cycle. Without
pre-ringing, the call starts ringing only when the normal ring cadence cycle occurs. This may cause
a ring delay, depending on when call detection occurs in reference to the ring cycle.
Input Data
Conditions
None
Feature Cross Reference
● Central Office Calls, Answering
Terminal Programming Instructions
To enter data for Program 10-08 (Pre-Ringing Setup):
1. Enter the programming mode.
2. 10 08
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press MIC once to enter a new item number.
OR
Press MIC until you’ve exited that series’s programming section.
Level:
Feature Availability
IN • Available.
Item No. Description Input Data Default
01 Pre-Ringing Setup 0 = disable
1 = enable
0
10-08-01
Pre-ringing 0:No
back
↑ ↓ select
10-08-nn
nnnnn
← −1 +1 →