System information

Program 26 : ARS Service
26-01 : Automatic Route Selection Service
UX5000 Software Program Manual Programming ◆ 493
Program 26 : ARS Service
26-01 : Automatic Route Selection Service
Description
Use Program 26-01 : Automatic Route Selection Service to define the UX5000 options for Auto-
matic Route Selection (ARS).
Input Data
Level:
Feature Availability
IN • Available.
Item No. Item Input Data Default
Related
Programs
01 ARS Service
Enable or disable ARS.
0 = Disable
1 = Enable
0 26-02
26-03
26-04
02 Network Outgoing Inter-Digit ARS Timer
With CygniLink, this timer replaces
20-03-04 when determining if all network
protocol digits have been received. If ARS is
enabled at Site B, this timer can be pro-
grammed for 5 (500 msec) at Site A. If ARS
is disabled and Site B is using F-Route for
outbound dialing, this timer should be pro-
grammed for 30 (3 seconds) at Site A.
0-64800 (msec.) 30 20-03-04
03 ARS Misdialed Number Handling
If a user dials a number not programmed in
ARS Dial Analysis Table (Program 26-02),
this option determines if the UX5000 should
route over trunk group 1 or play error tone.
0 = Route to Trunk
Group 1
1 = Play Warning
Tone to Dialer
0 21-02
26-02
04 LCR Mode - Not Used in the U.S. 0
05 - Not Used -
06 ARS COS Match Access
With the ARS Class of Service Match
Access feature, you can determine whether
the UX5000 should allow a call based on the
COS assigned to the Dial Analysis Table
(Program 26-02). This change can be used to
create a tenant-like application. It will then
use the trunk group defined in the Additional
Entry in Program 26-02-03 to place the out-
going call.
When this feature is enabled, the calls will
be routed in sequential order, and will for-
ward provided the Class of Service for the
trunk groups match.
0 = Disabled (COS
not compared)
1 = Enabled (COS
Match Access)
0 26-02