System information

Program 10 : System Configuration Setup
10-03 : Blade Setup
28 ◆ Programming UX5000 Software Program Manual
For VOIPDB
- INDEX-1 -
Conditions
● When changing a defined terminal type, first set the type to ‘0’ and then plug the new device
in to have the UX5000 automatically define it or redefine the type manually.
● The UX5000 must have a blade installed in order to view/change the options for that type of
blade.
Feature Cross Reference
None
Terminal Programming Instructions
To enter data for Program 10-03 (Blade Setup):
1. Enter the programming mode.
2. 10 03
3. Enter the number of the item you want to program.
4. Select the slot number to be programmed or press FLASH to use the displayed entry.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press MIC once to enter a new item number.
OR
Press MIC until you’ve exited that series’s programming section.
Physical Port Number 001-128
Item
No.
Item Input Data Default
01 Trunk Logical Port Number 0-200 0
02 H.323 or SIP Trunk
Determine the IP trunk type setup. If SIP trunking is used, this
reduces the number of ports on the VOIPDB card which can be used
for UX5000 IP terminals or IP CygniLink. With SIP trunking, some
ports must be defined for SIP.
0 = H.323
1 = SIP
1
10-03-01 Slot No 1
ESIport01 CH1 1 :TEL |1
back
↑ ↓ select
10-03-nn Slot No n
nnnnn
← − + →