System information

Program 10 : System Configuration Setup
10-03 : Blade Setup
UX5000 Software Program Manual Programming ◆ 25
13 Loss-Of-Signal Detection Limit 0 = Level 0 (Lowest Sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (Highest Sensitivity)
2
14 Service Protocol for S-Bus 0 = Keypad Facility
1 = Specified Protocol for UX5000
0
15 Alert Tone When S-Bus Terminal
Calls Busy Extension
This option determines for S-Bus ter-
minals what a user on an S-Bus ter-
minal will hear when a busy
extension is called. If this option is
set to "0", the user will hear an alert
tone. If this option is set to "1", the
user will be disconnected.
0 = Alert Tone
1 = Disconnected
0
16 ISDN 2 B-Channel Transfer
Enable or disable the 2 B-Channel
Transfer function for a PRI blade.
0 = Off/Disable
1 = On/Enable
0
17 ISDN Line ringback Tone 0 = Disable
1 = Enable
0
18 Type of Number
Use this option to define the ISDN
numbering plan to allow the calling
party information to be passed to
some telcos.
Within QSIG networks, a private
number plan may be used and
announced in the Called Party Num-
ber and Calling Party Number infor-
mation elements by the Number Plan
Indicator 9 (binary 1001). This can be
set in Programs 10-03-18 and
10-03-19.
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
3
19 Numbering Plan Identification
Set the type of information passed to
some telcos.
Within QSIG networks, a private
number plan may be used and
announced in the Called Party Num-
ber and Calling Party Number infor-
mation elements by the Number Plan
Indicator 9 (binary 1001). This can be
set in Programs 10-03-18 and
10-03-19.
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
1
Item
No.
Item Input Data Default