System information

Program 10 : System Configuration Setup
10-03 : Blade Setup
24 ◆ Programming UX5000 Software Program Manual
For PRIU Blade
Item
No.
Item Input Data Default
01 ISDN Line Mode 0 = Not set
1 = T-Bus
2 = S-Bus
3 = Network Mode (Leased Line)
4 = Network Mode (Interconnected Line)
5 = Network Mode (Interconnected Line, Fixed Layer 1=NT)
6 = S-Bus (Leased Line)
1
02 Logical Port Number
(see Note 1)
0 = No Setting
1 = For T-Bus (1-200)
2 = For S-Bus (1-512)
3 = Network Mode
4 = Network Mode
5 = Network Mode
6 = For S-Bus (Leased Line) (1-512)
0
03 CRC Multi-frame(CRC4)
(Only E1[30B+D] Mode)
0 = off
1 = on
1
04 Layer 3 Timer Type (see Note 2) 1-5 1
05 CLIP Information
Based on this setting, the UX5000
will include a “Presentation Allowed”
(1) or “Presentation Restricted” (0) in
the Setup message to allow or deny
the Calling Party Number. Program
15-01-04 must also be set to a ‘1’ if
this option is enabled.
0 = Disable
1 = Enable
1
06 Length of cable 0 = 0 40m
1 = 40 81m
2 = 81 122m
3 = 122 162m
4 = 162 200m
2
07 S-Bus DID Digits 0-4 0
08 Dial Sending Mode 0 = Enblock Sending
1 = Overlap Sending
0
09 Dial Information Element
(Only for Overlap Sending Mode)
0 = Keypad Facility
1 = Called Party Number
0
10 Master/Slave System (Network Mode
only)
0 = Slave System
1 = Master System
0
11 Networking System Number
(Network Mode only)
0-50 0
12 Short / Long-Haul 0 = short-haul
1 = long-haul
0