System information

Program 10 : System Configuration Setup
10-03 : Blade Setup
22 ◆ Programming UX5000 Software Program Manual
05 CLIP Information Announcement
Based on this setting, the UX5000 will
include a “Presentation Allowed” (1)
or “Presentation Restricted” (0) in the
Setup message to allow or deny the
Calling Party Number. Program
15-01-04 must also be set to a ‘1’ if
this option is enabled.
0 = Disable
1 = Enable
1
06 Connection Bus Mode (S-point only) 0 = Extended Passive Bus
1 = Short Passive Bus
0
07 S-Bus DID Digits 0-4 0
08 Dial Sending Mode 0 = Enblock sending
1 = Overlap sending
1
09 Dial Information Element
(Only for Overlap Sending Mode)
0 = Keypad Facility
1 = Called Party Number
0
10 Master/Slave System (NW mode only) 0 = Slave System
1 = Master System
0
11 Networking System Number (NW
mode only)
0-50 0
12 - Not Currently Used - 0
13 - Not Currently Used - 0
14 Service Protocol for S-Point 0 = Keypad Facility
1 = Specified Protocol for UX5000
0
15 Alert Tone When S-Bus Terminal
Calls Busy Extension
This option determines for S-Bus ter-
minals what a user on an S-Bus termi-
nal will hear when a busy extension is
called. If this option is set to "0", the
user will hear an alert tone. If this
option is set to "1", the user will be
disconnected.
0 = Alert Tone
1 = Disconnected
0
16 - Not Currently Used - 0
17 Ringback Tone to Telco
This option can be used to determine
whether or not the UX5000 sends ring-
back tone to the telco.
0 = Disable
1 = Enable
0